pah (şev)

listen to the pronunciation of pah (şev)
Türkçe - İngilizce
(İnşaat) chamfer
to cut a groove in something; to flute
to cut off the edge or corner of something; to bevel
an edge or end bevel that does not go all the way
To bevel the inside of a case mouth The bevel allows bullets to start into the case mouth without crushing the case
an angled relief or cut at an edge added for a finished appearance and to break sharp edges
The flat surface formed by cutting off a sharp corner, usually at an angle of 45 degrees
A bevelled edge made on a corner of a workpiece at 45 degrees
A beveled edge on a fastener The chamfer angle is measured from the normal to the axis of the fastener
surface made by cutting across the square angle of a stone block, piece of wood, etc , at an angle of 45° to the other two surfaces
{f} cut a sloping edge, bevel
A beveled edge
A simple bevel done for embellishment of a timber
{i} slope, slanted edge
The surface formed by cutting away the arris, or angle, formed by two faces of a piece of timber, stone, etc
A bevel, a corner or edge removed, a relief
A beveled or sloping edge (typically 45°) to reduce the sharp intersection of two faces
Corner of a board beveled at a 45angle Two board butt-jointed with chamfered edges form a V-joint
A sloping or bevelled edge
A beveled surface to eliminate an otherwise sharp corner