tabakalar halinde dizilim

listen to the pronunciation of tabakalar halinde dizilim
Türkisch - Englisch
delamination
The separation of the layers of a laminar composite material as a result of repeated stress, or failure of the adhesive
The act of splitting or separating a laminate into layers
(Embryology) The splitting of the blastoderm into two layers of cells to form a gastrula
Formation and separation of laminæ or layers; one of the methods by which the various blastodermic layers of the ovum are differentiated
A separation between plies within the base material, or between the base material and the conductive foil, or both
Separation of the plies in a laminated panel due ot failure of the adhesive, usually caused by excessive moisture or humidity
Delamination refers to the separation of the coating from the substrate It can also refer to separation between multiple layers of coating or even to cohesive failure of a coated part
Metal missing or retained but peeling from the surface due to incomplete bonding or impurities in the planchet
the separation of material constructed in layers in a direction approximately parallel to the surface
Separation of the secondary backing or attached cushion from the primary backing of the carpet
Separation of the plies in a roof membrane system or separation of laminated layers of insulation
This describes the separation of the individual plies in a laminate Laminates are typically made of two or more plies that are fused together under combinations of heat, pressure and adhesive When a lamination comes apart, delamination has occurred
The separation of the panel's face layer from the core, or a laminate from a substrate or separation of the inner plys usually from failure of the adhesive bond
the separation of a laminate along the plane of it's layers Also the separation of bonded insulation within the adhesive layer or at the adhesive interface
The separation of composite layers from each other Density: A comparison of weight per volume, measured in pounds per cubic foot Dielectric Strength: The value of a material as an electrical insulator or the resistance to the flow of electric current Dimensional Stability: A description of the change in size of an object during the molding process or in varying temperature conditions or under various loads Distortion: A change in shape form that which is intended Draft: The angle of the vertical components of a mold which allow removal of the part Drape: The ability of pre impregnated broad goods to conform to an irregular shape; textile conformity Dry Spot: Area of incomplete surface film on laminated plastics; in laminated glass, an area over which the interlayer and the glass have not become bonded
In-plane separation of a laminate ply or plies due to adhesive failure
The separation of layers of material in a laminate
The separation of the inner plies in a panel due to the failure of the adhesive bond
The separation of a laminate along the plane of its layers Also separation of bonded insulation within the adhesive layer or at the adhesive interface
subsurface separation of concrete into layers
tabakalar halinde dizilim
Favoriten