crossover cable

listen to the pronunciation of crossover cable
İngilizce - Türkçe
kros kablosu
İngilizce - İngilizce
A crossover cable is used to network two computers without using a hub Crossover cables may also be required for connecting a cable or DSL modem to a wireless gateway or Access Point Instead of traversing the cable in parallel paths between the plugs, the signals "crossover " For example, in an eight-wire cable, the signal entering on pin one at one end of the cable would exit on pin eight at the other end
A type of 10BaseT cable used to construct a two-system, hubless Ethernet network The advantage of such a network is cost, since you don't need to buy a hub to handle the packet switching There are disadvantages, though: You cannot expand beyond two systems, crossover cable networks tend to take more hand-holding and troubleshooting, and you often need to start up both systems at the same time
Special UTP cable used to connect hubs or to connect network cards without a hub Crossover cables reverse the sending and receiving wire pairs from one end to the other
A twisted-pair patch cable wired in such a way as to route the transmit signals from one piece of equipment to the receive signals of another piece of equipment, and vice versa This allows communication between two DTEs or two DCEs The opposite of a crossover cable is the straight-through cable
A twisted pair cable used only for a direct connection between a gas chromatograph and the PC network interface card (Agilent part number 5183-4649)
A type of networking cable in which some wires are reversed from one end to the other to join two computers or two hubs
A patch cord used to connect two computers together without a hub, or to daisychain hubs together when there is no uplink port on either hub
A cable whose wires cross so that the transmit pit in at one end is connected to receive pin at the other end
A cable with wires that "cross over," so the terminating ends of the cable have opposite wire assignments (Contrast with straight-through cable)
A cable in which receive and transmit lines (input and output) are crossed Crossover cables are sometimes needed to connect hubs together
This refers to an Ethernet cable using RJ-45 connectors, where one end of the cable is wired so that the Receive signal pins on one connector are connected to the Transmit signal pins on the other connector A Crossover Cable may be used to connect two 10BaseT or 100BaseT network cards, basically making a network of two computers, for example
A twisted pair patch cable wired in such a way as to route the transmit signals from one piece of equipment to the receive signals of another piece of equipment, and vice versa
Cat 5 cable in which the internal wiring crosses over; used to connect computer-to-computer or when no uplink ports are available on a hub
This is also called a "Crossed Cable " A Cat 5 or 5e cable that is used to connect one Personal Computer (PC) to another PC or one switch to another switch
Used to connect two computers directly with a single patch cable, so that the send wire from one computer is connected to the receive port on the other computer Crossover cables are useful in troubleshooting network connection problems
Cable used to connect two ethernet NIC cards A red crossover cable is supplied to connect the XpressDSL modem to the PC NIC card
crossover cable

    Heceleme

    cross·o·ver Ca·ble

    Türkçe nasıl söylenir

    krôsōvır keybıl

    Telaffuz

    /ˈkrôsˌōvər ˈkābəl/ /ˈkrɔːsˌoʊvɜr ˈkeɪbəl/